Answers are grounded in this paper and cite their sources.
In electrochemical machining (ECM), the inter-electrode gap changes during machining, so uniform machined dimensions are difficult to obtain and, in practice, a conservatively slow feed is used to avoid tool–workpiece contact. In this study, the machining voltage under constant-current ECM, which increases linearly with the gap, is used as a gap signal and fed back in real time to the feed rate of the tool electrode for dimple machining. In Model 1, the feed rate is controlled proportionally between a lower voltage threshold Vmin, set from the voltage at the initial gap, and an upper threshold Vmax. In Model 2, Vmin is lowered when the tool reaches the set depth so that the gap is narrowed again before the end of machining. The two models were compared at current densities from 30 to 165 A/cm2. Under all conditions, machining was completed without contact while the tool was fed at the maximum rate whenever the gap was wide. Model 2 considerably reduced the machining time at low and medium current densities and reduced the excessive depth at low current densities, whereas at high current densities a large gap remained at the end of machining in both models. The feed rate and machining depth in ECM can thus be controlled using only the machining voltage, without an additional displacement sensor.
No takes yet. Share an insight, caveat, or question.
Kim et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: