Answers are grounded in this paper and cite their sources.
This study evaluated selected physical, gravimetric, aerodynamic, and frictional properties of acha (Digitaria exilis) and sand relevant to the design of a de-stoning system. Measurements were conducted at a mean acha moisture content of 10.23% dry basis. One hundred randomly selected grains were measured for length, width, and thickness, while bulk density, true density, porosity, thousand-grain mass, angle of repose, coefficient of friction, terminal velocity, drag coefficient, and Reynolds number were determined using laboratory procedures. A sieve-gradation test was also performed on acha and sand using apertures from 2.36 mm to 106 μm. The mean length, width, and thickness of acha were 1.552, 0.853, and 0.791 mm, respectively; geometric mean diameter was 1.016 mm and sphericity was 65.50%. Mean thousand-grain mass, bulk density, true density, and porosity were 0.491 g, 598.9 kg m−3, 1127 kg m−3, and 46.90%, respectively. The mean angle of repose was 23.9°, while coefficients of friction were 0.44 on galvanized steel and 0.34 on fabric. The mean terminal velocity was 3.90 m s−1. For sand, mean thousand-grain mass, bulk density, true density, porosity, and angle of repose were 0.90 g, 1.45 g cm−3, 2.64 g cm−3, 45.08%, and 28.49°, respectively. The results indicate that density and frictional differences between acha and sand are potentially useful for gravity separation, while aerodynamic properties provide design parameters for air-assisted separation. The findings provide baseline engineering data for the development and optimization of acha de-stoning equipment
No takes yet. Share an insight, caveat, or question.
Bature et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: