Answers are grounded in this paper and cite their sources.
In this work, we investigate the synthesis and characterization of the ZnS layer as an alternative Cd-free buffer layer for Cu(In,Ga)Se 2 (CIGS) thin film solar cells, The ZnS nanopowders were successfully prepared via solvothermal method, then employed to fabricate thin films deposited by rf-magnetron sputtering. Their structural, morphological and optical characterizations were performed. In addition, these experimental data obtained were further implemented in numerical simulations of a p-CIGS/n-ZnS heterojunction using SCAPS-1D. The impact of different buffer layer materials CdS and ZnS on the performance of CIGS solar cells was thoroughly compared and analyzed. The obtained results demonstrate that, the films crystallize in the cubic phase with grain sizes ranging from 4 to 20 nm and exhibiting high transparency (> 90%), with a tunable band gap in the range of 3.68 to 3.8 eV. The tuning of the deposition conditions allows ZnS to achieve proper band alignment with the CIGS absorber. The optimized structure revealed that, both the buffer material and their thickness significantly influence the overall device performance. The substitution of the conventional CdS buffer with ZnS this possesses a wider bandgap, resulted in lower conversion efficiency due to unfavorable energy band alignment at the interface. To overcome this limitation and enhance short-wavelength absorption, a novel CdS/ZnS double buffer layer structure was proposed. The optimization of this configuration improved the cell efficiency from 22.62% to 24.68%. These results indicate the potential of ZnS-based buffers as promising and environmentally friendly alternatives for high efficiency CIGS solar cells.
No takes yet. Share an insight, caveat, or question.
Mouhoub et al. (2026) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: