Key result
Eccentric carotid stenosis increases peak velocity ~43% and raises wall shear stress vs concentric lesions.
Why the study?
Expressing carotid artery stenosis severity as a percentage reduction in diameter or area does not fully capture the combined effects of lesion morphology, blood rheology, and flow-regime assumptions on the arterial mechanical environment.
Computational fluid dynamics modeling demonstrates that carotid stenosis percentage alone is insufficient to characterize hemodynamic burden, as eccentric lesion morphology, non-Newtonian blood rheology, and turbulence jointly increase peak velocity, pressure loss, wall shear stress, and post-stenotic recirculation.
Answers are grounded in this paper and cite their sources.
Shape and rheology alter hemodynamics beyond percent stenosis; leaves open whether morphology augments clinical risk assessment in carotid disease.
Carotid artery stenosis alters local haemodynamics through lumen reduction, jet acceleration, pressure loss, flow separation and post-stenotic disturbance. Although stenosis severity is commonly expressed as a percentage reduction in diameter or area, this scalar descriptor does not fully capture the combined effects of lesion morphology, blood rheology and flow-regime assumptions on the arterial mechanical environment. The present work develops a computational fluid dynamics framework for comparing healthy and stenosed carotid bifurcation flow under controlled peak-systolic conditions. A healthy reference geometry and two idealized 60% stenosis morphologies, one symmetric/concentric (S1) and one sharper eccentric ellipsoid (S2), are analysed using rigid-wall incompressible flow simulations. Blood is represented using both Newtonian and Carreau–Yasuda shear-thinning constitutive descriptions, while laminar calculations are compared with turbulence k–ω SST Reynolds-Averaged Navier–Stokes (RANS) simulations as a sensitivity assessment of disturbed post-stenotic flow. The results show that stenosis percentage alone is insufficient to characterize haemodynamic burden. Under Newtonian laminar conditions, the maximum velocity increased from 1.105 m s⁻¹ in the healthy configuration to 1.477 m s⁻¹ in S1 and 1.581 m s⁻¹ in S2, corresponding to increases of approximately 34% and 43%, respectively. The corresponding pressure drop increased from 1276 Pa to 1583 Pa and 1626 Pa. Similar trends were obtained in the Newtonian RANS calculations, where the maximum velocity was 1.103, 1.478 and 1.582 m s⁻¹ for H, S1 and S2, respectively, and the corresponding pressure drops were 1277, 1585 and 1627 Pa. In the Newtonian RANS simulations, peak wall shear stress increased from 271 Pa in the healthy model to 302 Pa in S1 and 378 Pa in S2, indicating a substantially more concentrated near-wall mechanical load in the eccentric stenosis. The Carreau–Yasuda simulations indicate that rheological effects are most evident in low-shear post-stenotic regions rather than at the stenotic throat. Under laminar non-Newtonian conditions, S2 increased the maximum velocity by approximately 12% relative to the healthy case and produced a larger pressure loss than S1, with Δp increasing from 390 Pa in S1 to 463 Pa in S2. Peak wall shear stress also increased from 69 Pa in S1 to 97 Pa in S2. Recirculation metrics further confirmed the effect of lesion morphology: in the laminar Carreau–Yasuda simulations, the lower-wall post-stenotic recirculation length increased from 9.27 mm in S1 to 14.12 mm in S2, while in the turbulence Carreau–Yasuda simulations it increased from 11.17 mm to 17.34 mm. The steady-state formulation is interpreted as a first-order peak-systolic approximation, not as a substitute for transient patient-specific modelling. Likewise, geometry is anatomically inspired rather than patient-specific, allowing lesion-shape effects to be isolated without claiming diagnostic prediction. Overall, the study supports a mechanistic interpretation of carotid stenosis in which lesion morphology, blood rheology and local flow disturbance jointly determine the spatial distribution of clinically relevant haemodynamic indices. Future work should extend the framework to pulsatile inflow, compliant walls, patient-specific imaging and direct validation against Doppler ultrasound, phase-contrast magnetic resonance imaging or in vitro phantom measurements.
No takes yet. Share an insight, caveat, or question.
Tsolakidis et al. (2026) studied Carotid artery stenosis. Idealized 60% carotid stenosis morphologies (symmetric/concentric S1 and eccentric ellipsoid S2) under Newtonian and Carreau-Yasuda CFD simulations vs. Healthy reference carotid bifurcation geometry was evaluated on Haemodynamic parameters (maximum velocity, pressure drop, peak wall shear stress, and post-stenotic recirculation length). Eccentric 60% carotid stenosis (S2) increased peak velocity by 43% and wall shear stress to 378 Pa (vs 302 Pa in concentric S1 and 271 Pa in healthy models) in CFD simulations.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: