Answers are grounded in this paper and cite their sources.
Direct conversion of polyolefin waste into ethylene is hindered by poor control over heat transfer, intermediate transport, and secondary cracking. Here we introduce a catalytic spatiotemporal Joule‐heating strategy integrating polymer melting, transport, and catalytic conversion within a three‐layer architecture. Transient pulses create a localized high‐temperature catalytic zone while underlying layers remain thermally buffered. Experiments and simulations support a thermal‐catalytic control involving progressive cracking, localized catalytic conversion, and rapid light‐product removal. Under optimized conditions, low‐density polyethylene affords a C 1 – C 5 hydrocarbon yield of 96.0 wt%, an ethylene molar selectivity of 49.4% based on the quantified C 1 – C 5 gaseous hydrocarbons, and a specific ethylene yield of 14.3 mmol g −1 . The strategy also accommodates other polyolefins and post‐consumer plastics. Within the defined life‐cycle boundary, cumulative energy demand and greenhouse‐gas emissions decrease by approximately 47.7% and 36.5%, respectively, relative to the conventional PE ‐to‐naphtha and steam‐cracking route.
No takes yet. Share an insight, caveat, or question.
Huang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: