Answers are grounded in this paper and cite their sources.
Subwavelength-grating microring resonators (SWGMRRs) are promising devices for enhancing light–matter interaction in evanescent-field photonic sensors. Here, we design, fabricate, and experimentally characterize silicon nitride (Si 3 N 4 ) SWGMRRs by varying waveguide widths under aqueous cladding at 1,550 nm. For the 1.2-µm-wide device under transverse-electric (TE) polarization, we demonstrate a bulk refractive index sensitivity ( S b ) of 398 nm/RIU, an intrinsic quality factor ( Q i ) of 1.3 × 10 4 , and an intrinsic limit of detection (iLOD) of 3.0 × 10 −4 RIU. In comparison, a conventional Si 3 N 4 strip microring resonator (SMRR) with the same width and thickness, fabricated on the same chip and characterized under identical conditions, exhibits an S b of 128 nm/RIU, a Q i of 5.7 × 10 4 , and an iLOD of 2.1 × 10 −4 RIU. Numerical analysis predicts a surface sensitivity ( S s ) of 5.3 × 10 −4 RIU/nm for the SWGMRR compared with 1.6 × 10 −4 RIU/nm for the SMRR under TE polarization. To the best of our knowledge, this is the first experimental refractive-index sensing demonstration using a Si 3 N 4 microring in which the sensing ring is implemented entirely as a subwavelength-grating waveguide. The results establish a significant enhancement in measured bulk sensitivity and calculated surface sensitivity, while revealing a sensitivity–quality factor trade-off that yields a higher iLOD than the same-width SMRR. These findings support further investigation of Si 3 N 4 SWGMRRs for applications that prioritize enhanced bulk and surface sensing response.
No takes yet. Share an insight, caveat, or question.
Taleghani et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: