Answers are grounded in this paper and cite their sources.
The AlSi5Cu2Mg alloy for cylinder-head castings is known for its pronounced susceptibility to hot tearing. This study examines how niobium additions affect the hot tearing susceptibility (HTS) of this alloy. Niobium was introduced via an AlNb10 master alloy in nominal amounts of 0.10, 0.15 and 0.20 wt.% (measured 0.049, 0.063 and 0.076 wt.%). HTS was evaluated quantitatively, by three variants of the hot tearing index (HTI) determined from tears on four arms of a five-arm restrained-contraction mould, and qualitatively, from the load recorded on the fifth, anchored arm. All niobium additions reduced the HTI values. The lowest values were obtained for the nominal 0.15 wt.% addition (HTI1 = 0.18, HTI2 = 0.60 and HTI3 = 0.17 compared with 0.93, 2.35 and 1.91 for the reference alloy). In the qualitative evaluation, this was the only alloy in which no anchored arm separated. In contrast, two anchored arms of the 0.20 wt.% Nb alloy separated immediately and a third transferred less than 120 N. This occurred despite the finest dendritic structure (secondary dendrite arm spacing 16.58 versus 25.76 µm). Niobium can therefore reduce the HTS of the AlSi5Cu2Mg alloy, with the most favourable effect at a nominal addition of 0.15 wt.%.
No takes yet. Share an insight, caveat, or question.
Sýkorová et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: