Answers are grounded in this paper and cite their sources.
The growing amount of polyethylene terephthalate (PET) waste and the need to reduce the consumption of natural mineral resources justify exploring the use of PET granules in cementitious composites. One potential direction is its use as a lightweight aggregate component, influencing both the thermal and mechanical properties of concrete. This article presents the results of research on the effect of PET granules on the thermal conductivity of concrete within the investigated temperature range of 0–25 °C and on selected physical and mechanical properties of the material. The aim of the study was to determine the effect of temperature and PET content on the thermal conductivity coefficient, density, and compressive strength of concrete. Three mix variants were prepared: the REF reference concrete and PET50 and PET100 mixes, corresponding to nominal 50% and 100% volumetric replacement levels, respectively, of the natural 2/8 mm aggregate fraction with recycled PET granulate. The replacement levels were defined at the mix-design stage using the adopted densities of the natural aggregate and PET granulate. For thermal conductivity testing, four plate samples were made for each blend variant, measuring 300 × 300 × ~42 mm. Measurements were conducted in accordance with ISO 8301 using a FOX314 plate apparatus, with average sample temperatures ranging from 0 to 25 °C. A total of 72 thermal conductivity measurements were taken. The research program was supplemented by determining the density and compressive strength of 54 cubic samples measuring 150 × 150 × 150 mm. The thermal conductivity coefficient increased with increasing temperature, while its value decreased significantly with increasing PET granulate content. At 25 °C, the average λ value was 1.4559 W/(m·K) for the REF mixture, 0.7778 W/(m·K) for PET50, and 0.6492 W/(m·K) for PET100, which corresponded to reductions of approximately 46.6% and 55.4%, respectively, compared to the reference concrete. Simultaneously, the average density of the cubic samples decreased from 2344 kg/m³ for REF to 2257 kg/m³ for PET50 and 2171 kg/m³ for PET100. The average compressive strength decreased from 31.92 MPa to 27.30 MPa and 23.34 MPa, respectively. The obtained results indicate the potential of PET-modified concrete for applications in which reduced thermal conductivity and lower density are advantageous; however, suitability for specific applications requires additional assessment of durability and other application-dependent properties.
No takes yet. Share an insight, caveat, or question.
Trepka et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: