Answers are grounded in this paper and cite their sources.
This study aims to systematically investigate and quantify the influence of graphene oxide (GO) film thickness, spectral width, chemical reduction time, and substrate refractive index on the optical response of the system. A transfer matrix method was employed to model the optical response over the ultraviolet–visible spectral range of 200–800 nm for GO thicknesses of 50–90 nm, spectral-width parameters σ G O = 40 –80 nm, reduction times of 0–1 h, and substrate refractive-index dispersion of 1.5–3.46. Transmittance, reflectance, absorptance, optical phase, phase time, and group velocity were evaluated. The results demonstrate strong parameter-dependent optical behavior, particularly in the UV region. Increasing the GO thickness from 50 to 90 nm reduces the UV transmittance from approximately 0.25 to below 0.15 and produces an optical phase variation of up to approximately 2 rad, indicating enhanced phase accumulation and dispersion. Increasing the spectral-width parameter σ G O from 40 to 80 nm modifies the modeled extinction profile, particularly in the UV region, and consequently affects the calculated transmittance and absorptance. The substrate also strongly influences the optical response. A high-refractive-index T i O 2 substrate provides visible-range transmittance exceeding approximately 0.70 under the investigated conditions owing to modified optical matching and interference at the GO/substrate interface. Within the adopted phenomenological model, increasing the reduction-time parameter from 0 to 1 h produces lower transmittance and higher absorptance, with the strongest changes occurring in the near-UV/blue spectral region, while also modifying the phase-time and phase-derived group-velocity responses. Overall, the results demonstrate that thickness, spectral width, reduction state, and substrate optical properties provide complementary degrees of freedom for tailoring the amplitude, phase, and dispersive response of GO thin films. These findings provide quantitative guidance for assessing and tuning the optical response of GO-based photonic, optoelectronic, and sensing structures.
No takes yet. Share an insight, caveat, or question.
Maachi et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: