Answers are grounded in this paper and cite their sources.
To decrease the emission of hazardous NOx in iron and steel metallurgy and waste-to-energy incineration, it is crucial to develop solid-state electrolyte-based NH3 sensors compatible with the low-temperature selective catalytic reduction system. However, existing NH3 sensors require operating temperatures above 400 °C for stable operation and adequate sensitivity, which limits their use at 100–300 °C. Thus, the heterogeneous low-temperature SnO2/1% Co3O4 sensing electrode (SE) is developed and integrated with the CuV2O6 SE on a solid-state electrolyte for improving the sensitivity of solid electrolyte NH3 sensors at low operation temperature. The introduction of heterojunctions enhances the response signal of the SnO2/1% Co3O4 sensor in low-temperature ranges by reducing the interfacial charge transfer resistance associated with electrochemical reactions on the SE. Because of the superposition enhancement effect of SEs, the sensitivities of the SnO2/1% Co3O4-CuV2O6 sensor with two SEs increase by 93.5 and 72.8% on average compared to that of the SnO2/1% Co3O4 sensor and the CuV2O6 sensor respectively, and reach the largest sensitivity of –74.9 mV/decade at 200 °C. The developed SnO2/1% Co3O4-CuV2O6 sensor exhibits a calculated limit of detection of 0.14 ppm NH3, together with good anti-interference properties and stability. This work provides an effective way to develop low-temperature solid electrolyte gas sensors with large sensitivity.
No takes yet. Share an insight, caveat, or question.
Kong et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: