Answers are grounded in this paper and cite their sources.
Friction stir welding (FSW) of AA3003 aluminum alloy is governed by the tool rotational speed (𝑁), feed rate (𝑆), and tilt angle (𝜃). Earlier studies on this alloy have used these parameters to model either the tensile properties or the welding temperature, but these responses have rarely been analyzed together with the hardness of the weld zones. In this study, a three-level full factorial design and response surface methodology (RSM) were used to model four responses: the ultimate tensile strength (𝜎 U ), the maximum temperature (Tmax) recorded 10 mm from the weld centerline, and the hardness of the nugget zone (NZ) and the heat-affected zone (HAZ). Within the tested ranges, the tilt angle had the largest effect on Tmax, whereas the rotational speed had the largest effect on NZ hardness and 𝜎 U . Increasing 𝑁 or 𝜃 raised Tmax and lowered the hardness of both zones, while 𝜎 U increased with 𝑁 and varied nonlinearly with 𝑆, with a minimum near the intermediate feed rate. A multi-response optimization that maximized 𝜎 U and hardness gave 𝑁 = 1000 rpm, 𝑆 = 400 mm/min, and 𝜃 = 0.5°. At this setting, the predicted 𝜎 U and the NZ and HAZ hardness reached about 77%, 89%, and 80% of the base metal values, respectively. Eight independent validation tests gave coefficients of determination (R²) between 0.818 and 0.919. The models describe the parameter effects within the tested domain and can support the selection of welding conditions for AA3003 joints.
No takes yet. Share an insight, caveat, or question.
Belaribi et al. (2026) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: