Answers are grounded in this paper and cite their sources.
Pd‐doped Bi 2 Te 3 thin films were deposited on Al 2 O 3 substrates using magnetron cosputtering with direct‐current (DC), pulsed‐DC (DC‐P), and high‐power impulse magnetron sputtering (HiPIMS) to investigate the effects of deposition configuration and annealing on microstructure and thermoelectric (TE) transport. HiPIMS was selectively applied to either the Bi 2 Te 3 or Pd target, followed by vacuum annealing at 250 °C. Deposition rates increased when HiPIMS was applied to the Pd target but decreased when applied to the Bi 2 Te 3 target. FESEM revealed nanocolumnar films approximately 400 nm thick, while annealing promoted grain growth and microstructural evolution. GI‐XRD and HRTEM indicated improved crystalline ordering, with additional diffraction features suggesting possible PdTe 2 secondary‐phase formation. Hall‐effect and temperature‐dependent TE measurements revealed deposition‐dependent changes in carrier transport. All films exhibited n‐type conduction. Among the investigated configurations, annealed DC‐P (Bi 2 Te 3 )/HiPIMS (Pd) films achieved the highest Seebeck coefficient magnitude of 78.10 μV K −1 and maximum power factor of 0.91 μW cm −1 K −2 at 200 °C. These findings demonstrate the importance of target‐selective HiPIMS and annealing in controlling microstructure and TE transport in Pd‐containing Bi 2 Te 3 thin films.
No takes yet. Share an insight, caveat, or question.
Chaiwas et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: