Answers are grounded in this paper and cite their sources.
Naphtha is highly volatile, contains a complex organic matrix, and typically has very low mercury (Hg) levels, making accurate ultratrace Hg determination strongly dependent on sample pretreatment. Here, an HNO3/L-cysteine (L-Cys)-assisted pretreatment coupled with cold-vapor atomic fluorescence spectrometry (CV-AFS) was developed for Hg analysis in naphtha. CV-AFS showed good linearity over the tested concentration range (R2 = 0.999954). Increasing the HNO3 concentration markedly increased the measured Hg concentration and produced a plateau at 20–25% HNO3, indicating that pretreatment is a key limitation for ultratrace Hg analysis. Addition of L-Cys further increased the Hg response under most HNO3 conditions, with an evident dependence on acidity. The highest response was obtained with 20% HNO3 and 20 g L−1 L-Cys. In real naphtha samples, the proposed method quantified Hg at 0.0406 and 0.0560 μg L⁻¹ in two samples for which SGS reported results below its laboratory reporting threshold (0.0700 μg L⁻¹ after conversion). These results indicate that HNO3 promotes Hg release and aqueous-phase transfer, while L-Cys assists Hg capture and stabilization, thereby improving the quantitative analysis of ultratrace Hg in naphtha.
No takes yet. Share an insight, caveat, or question.
Yu et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: