Answers are grounded in this paper and cite their sources.
During the lamination process of photovoltaic module stacks, the filling of gaps along solar cell edges by the encapsulant film affects local encapsulation quality. As the polyolefin elastomer (POE) film softens with heating, pressing drives it into these gaps. The resulting filling depends on the pressing conditions. However, the impact of pressing parameters on the average filling rate and coverage at different edge locations remain unclear. This study employed a three-dimensional transient numerical model to examine the effects of pressing duration, displacement, and velocity profile on POE gap filling. With a displacement of 12 μm per glass layer, the 200 s case achieved the highest filling rate among the durations examined, reaching 85.84%. Extending pressing beyond 200 s did not improve the overall filling fraction. Increasing the displacement primarily improved filling beneath the short edge and at the outer edge of the gap, although the gain diminished at larger displacements. At the same displacement and duration, the half-sinusoidal velocity profile produced a higher filling rate than the early-slow profile. These results inform the selection of lamination parameters for double-glass photovoltaic module stacks with ultrathin silicon cells and provide an approach for evaluating gap filling across different cell and POE film dimensions.
No takes yet. Share an insight, caveat, or question.
Zhou et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: