Answers are grounded in this paper and cite their sources.
Wake losses are an important factor limiting wind farm power generation. Although micrositing and active yaw control can mitigate wake losses, they are typically optimized separately, with limited consideration of their coupling. This study proposes a joint optimization framework that considers wind farm micrositing and active yaw control simultaneously. A genetic algorithm (GA) is used to optimize turbine layouts, while the serial refinement (SR) algorithm is embedded in the fitness evaluation of each candidate layout to optimize yaw angles. The Lillgrund offshore wind farm in Sweden is selected as the case study, considering the full range of wind conditions represented by the site wind rose. Relative to the original layout under maximum power point tracking (MPPT) control, micrositing alone, yaw control alone, and sequential optimization of micrositing followed by yaw control increase wind farm power output by 7.87%, 1.72%, and 9.08%, respectively, while joint optimization achieves the largest increase of 9.18%. Although the jointly optimized layout produces 0.06% less power than the layout obtained by micrositing alone under MPPT operation, the yaw control gain increases from 1.13% for the latter to 1.27% for the jointly optimized layout, resulting in 0.10% higher power after yaw control than sequential optimization. These results demonstrate that micrositing and yaw control are closely coupled. Considering yaw control potential during micrositing can further improve wind farm power generation.
No takes yet. Share an insight, caveat, or question.
Yang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: