Answers are grounded in this paper and cite their sources.
Achieving simultaneously high solar absorptance and low thermal emittance remains a key challenge for solar-selective absorber (SSA) coatings on porous polymer substrates. The thin coating cannot fully prevent the underlying high-emittance substrate from radiating heat, resulting in greater radiative heat loss. Here, an Al-backed multilayer coating comprising high- and low-metal-volume-fraction NbTaTiV-N layers and a Si3N4 antireflection layer was deposited by magnetron sputtering. Nitrogen flow was used to tune the spectral response of the NbTaTiV-N layers. On a stainless steel substrate, the trilayer absorber exhibited a solar absorptance of 96.3% and a reported infrared-band emittance of 10.5%. Direct deposition of this stack on a porous synthetic chamois substrate increased solar absorptance from 22.8 to 75.7%, but the infrared-band emittance remained high at 89.3%. Inserting an Al reflector and assembling the selected absorbing layers produced a solar absorptance of 96.0% and an infrared-band emittance of 29.9%. In the outdoor test, both coated samples were hotter than uncoated PVA. Solar absorptance remained between 94.7 and 95.6% after direct deposition on cotton, Al, and Cu, whereas infrared-band emittance varied from 7.2 to 32.4%. The Al interlayer therefore improves spectral selectivity on high-emittance substrates.
No takes yet. Share an insight, caveat, or question.
Zhang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: