Answers are grounded in this paper and cite their sources.
Catalytic epoxidation of olefins with hydrogen peroxide has been recognized as an attractive route to produce epoxy compounds. In this work, an experimental dataset on the epoxidation of C8 olefins, including 1-octene, cyclooctene, trans-4-octene, and cis-4-octene, was generated for commercial titanium silicalite-1 (TS-1) and an immobilized peroxotungstate catalyst supported on a polymer matrix (A-PWx/PS). The catalysts were compared in terms of conversion, epoxide selectivity, epoxide yield, recyclability, TON, and TOF. TS-1 showed high activity toward 1-octene and 4-octenes, but its performance in cyclooctene epoxidation was strongly limited, with conversion not exceeding 7% after 6 h. In contrast, A-PWx/PS reached >99% conversion and >99% selectivity in cyclooctene epoxidation, with TON and TOFavg values of 266 and 44.3 h–1, respectively, and retained high catalytic performance over five consecutive cycles. To rationalize these trends, the experimental data were combined with substrate descriptors, including kinetic diameter, permanent dipole, and quantum-chemical parameters of the C═C bond, and analyzed using interpretable machine learning. SHAP analysis revealed that catalyst architecture, reaction time, steric accessibility, and C═C electron-donating ability determine the conversion–selectivity–stability balance. The results demonstrate that A-PWx/PS is a promising and stable heterogeneous catalyst for selective epoxidation with hydrogen peroxide.
No takes yet. Share an insight, caveat, or question.
Esipovich et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: