Answers are grounded in this paper and cite their sources.
Generative design produces structurally efficient but organically shaped geometries that require post-processing before Fused Deposition Modeling (FDM) manufacturing. This paper compares two post-processing strategies applied to the same generative design outcome for an Unmanned Aerial Vehicle (UAV) tail boom: a complex variant faithful to the raw topology, and a simplified variant with symmetric arms, self-supporting geometry, and uniform cross-sections oriented toward FDM manufacturability. Both variants were evaluated using linear static and buckling finite element analysis underidentical loading conditions. Scaled prototypes of the simplified variant were FDM-printed at two infill configurations and physically load-tested. The manufacturing-oriented simplification reduced both mass and print time while eliminating support structures; peak stress remained well below the material limit. FEA-predicted stress concentrations correlated with observed fracture locations in physical tests. For lightly loaded polymer FDM structures, these results suggest that manufacturing-oriented simplification of generative design outcomes incurs a negligible structural penalty while improving printability and reducing production cost.
No takes yet. Share an insight, caveat, or question.
Kowalik et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: