Answers are grounded in this paper and cite their sources.
Bench‐scale lubricant screening is often reduced to mean friction, although friction, disk wear, and counterface wear may rank formulations differently. Four supplier‐designated polyalkylene glycol (PAG) oils and four PAG‐1/PAG‐3 binary blends were evaluated using an immersed AISI 52100 steel ball‐on‐disk protocol adapted from ASTM G99‐23. Tests were conducted at 10 N, 0.10 m s −1 , 360 m, and 25°C ± 1°C, with three replicates per formulation. Mean coefficient of friction (COF), disk‐track width, maximum track depth, and area‐equivalent ball‐scar diameter were measured. An empirical exponential‐logistic function was also fitted to the formulation‐level mean COF traces to describe their temporal evolution. Formulation effects were significant for mean COF and all three wear dimensions (one‐way ANOVA, p < 0.001). PAG‐3 produced the lowest mean COF (0.028 ± 0.001) and shared the low‐friction Tukey group with PAG‐1, whereas PAG‐2 produced the lowest geometry‐based disk and ball‐wear estimates. All blends exhibited mean COF values above those of both neat‐parent oils and the linear interpolation between their measured means. The 50/50 blend produced the lowest friction and wear estimates within the blend series but was not uniquely superior in all Tukey comparisons. These results demonstrate that low friction does not necessarily indicate low wear. Initial lubricant screening should therefore combine time‐resolved friction with separate disk‐ and counterface‐wear metrics rather than rely on mean friction alone.
No takes yet. Share an insight, caveat, or question.
Ahmed et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: