Answers are grounded in this paper and cite their sources.
Ozone nanobubbles (O 3 /NB) were evaluated for treating marine oil-in-water emulsions. Stable nanoscale bubble populations (<200 nm), with an apparent mean diameter as low as 9.15 ± 0.64 nm after 30 min at an ozone input of 55.56 mg/L, enabled more than 60% oil removal within 5 min under selected conditions and near-complete removal within 60 min over an initial oil concentration range of 98-511 mg/L. The observed treatment performance likely reflects the combined contributions of physical flotation and ozone-mediated oxidation. Biphasic kinetics were observed, with higher initial rate constants at increased ozone input. Conventional heavy crude oil (CHCO) exhibited faster apparent degradation than very low sulfur fuel oil (VLSFO), likely reflecting differences in their overall composition and physicochemical properties. Post-treatment analyses revealed residual total petroleum hydrocarbon (TPH) concentrations ranging from below 0.1 to 3.5 mg/L, with most of the 16 target parent polycyclic aromatic hydrocarbons (PAHs) below the approximate reporting limit of 8 ng/L. The observed pH decline may reflect the formation of acidic oxidation products and nitrogen-containing by-products from air-fed ozone generation. These results demonstrate that ozone nanobubbles enable efficient oil removal and substantial petroleum hydrocarbon attenuation in oil-in-water emulsions under controlled marine conditions.
No takes yet. Share an insight, caveat, or question.
Deng et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: