Answers are grounded in this paper and cite their sources.
Demonstration fusion reactor (DEMO) will aim to fulfill the tritium self-sufficiency in fuel recycling and generate economical fusion energy in the future. Tritium self-sufficiency is one of the key requirements for future fusion reactors. In water-cooled solid breeder blankets, the cooling-channel geometry affects neutron moderation and consequently influences the spatial distribution of tritium breeding. This study quantitatively evaluates the effect of cooling pipe diameter on near-pipe tritium accumulation and tritium release potential in a PWR water-cooled solid breeder blanket. Five cooling pipe diameters, 5.6, 7.5, 9.3, 11.3, and 13.8 mm, are considered using local tritium production densities extracted at positions far from and close to the cooling pipe. Three indicators are introduced, the tritium production density difference, the near-pipe enhancement ratio, and the tritium accumulation factor. The results show that as the cooling pipe diameter increases from 5.6 to 13.8 mm, the near-pipe tritium production density increases from 1.37 × 1013 to 1.88 × 1013 n × s−1 × cm−3, whereas the far-pipe value changes only slightly from 1.26 × 1013 to 1.32 × 1013 n × s−1 × cm−3. The enhancement ratio increases from 8.7% to 42.4%, and the accumulation factor increases from 1.087 to 1.424. These results indicate that increasing the cooling pipe diameter mainly intensifies local tritium accumulation in the low-temperature region around the cooling pipe rather than uniformly increasing tritium production throughout the breeder zone. Therefore, cooling pipe diameter optimization should consider heat removal, tritium breeding performance, and tritium release potential simultaneously.
No takes yet. Share an insight, caveat, or question.
Li et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: