Answers are grounded in this paper and cite their sources.
The orthogonal orientation of wood may influence bonding quality in glued laminated timber (Glulam) elements due to anatomical and physical differences between the radial and tangential planes. This study investigated the influence of bonding surface orientation and adhesive type on the bonding quality of Glulam elements manufactured from Australian red cedar ( Toona ciliata ) wood. Two structural adhesives were evaluated: AG101 two-component polyurethane and RS-216-M resorcinol-formaldehyde two component, combined with five bonding configurations involving radial and tangential planes. Bonding quality was assessed through bond line shear strength, wood failure percentage, glue line thickness, and delamination tests. The results showed that configurations composed of tangential surfaces exhibited higher shear strength and wood failure percentage, whereas the radial-to-radial configuration showed the lowest values for both adhesives. Radial surfaces exhibited greater roughness and thicker glue lines. The polyurethane adhesive showed greater penetration into the wood and produced thinner glue lines, whereas the resorcinol-formaldehyde adhesive resulted in lower delamination values. It was concluded that the orthogonal orientation of wood significantly influences bonding performance and should therefore be considered in the manufacture of structural Glulam elements from Australian red cedar.
No takes yet. Share an insight, caveat, or question.
Oliveira et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: