Answers are grounded in this paper and cite their sources.
BACKGROUND: To evaluate the biomechanical performance and efficiency of a barbed, knotless side-to-side (STS) tenorrhaphy versus a traditional running cross-stitch STS repair in a cadaveric tendon transfer model. METHODS: Flexor digitorum superficialis and profundus tendons (index, middle, and ring) from 5 fresh-frozen male cadaveric forearms (mean age 52.2 years) were harvested and randomized into 2 groups (n = 12/group). Each pair underwent a 3-cm overlap STS tenorrhaphy with either cross-stitch with a 3-0 braided polyester (Ethibond) or barbed running grasping repair with 2-0 barbed monofilament PDS (Stratafix). After 200 preconditioning cycles at 0.5 Hz to 10% strain (≤30 N), constructs were pulled to failure at 1 mm/s. Primary outcomes were ultimate load and stiffness; secondary outcomes included force reduction after cyclic loading and operative time. Displacement at failure was similar (~19-20 mm). Force reduction with cyclic loading did not differ (39% ± 11% vs 34% ± 16%). Barbed repair time was 27.2% shorter (199 vs 272 seconds). CONCLUSION: Both STS techniques demonstrated ultimate loads substantially greater than the 15 to 35 N forces reported during passive motion and early active postoperative flexor tendon rehabilitation protocols; however, barbed constructs were approximately 33% weaker and less stiff than cross-stitch repair despite reduced operative time. Although barbed STS repair may have utility in select situations, running cross-stitch repair remains the biomechanical benchmark, and further optimization and clinical validation of barbed constructs are needed before broader adoption.
No takes yet. Share an insight, caveat, or question.
Jacoby et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: