Answers are grounded in this paper and cite their sources.
The development of sustainable biosorbents from lignocellulosic biomass is often limited by low yield and the energy-intensive fractionation required to enhance specific components and tailor their physicochemical properties for industrial scalability. To address this, an I-optimal response surface methodology (RSM) optimization approach was used to optimize the parameters of the acid-assisted hydrothermal activation process for coir fibers, simultaneously maximizing cellulose yield and methylene blue (MB) removal efficiency. The synergistic effects of acid concentration (0.5–1.0 mol/L), temperature (90–160 °C), activation time (30–150 min), and acid type (HCl, H3PO4) were evaluated. 1.0 mol/L HCl stood out, and the linear model was the best fit for both cases; the acid type influenced MB removal efficiency, while temperature and time negatively impacted the cellulose yield. Optimal conditions (1.0 M HCl, 120 °C, 90 min) achieved a balanced performance with 80.6% cellulose yield and MB removal efficiency (90.7%, 9.07 mg/g). The distinct mesoporous profile framework and the shift of surface charge from 5.8 to 2.1 pHpzc were confirmed by BET surface analysis and the point of zero charge plot. Adsorption of MB onto the surface of the modified coir fiber adsorbents was endothermic chemisorption (ΔH0 = +117.84 kJ/mol) and underwent a spontaneous shift at elevated temperature (45 °C), well fitted by Temkin, Langmuir, pseudo-second-order kinetic (PSO), and intraparticle diffusion (IPD) models for describing the adsorption mechanism. The maximum efficiency (97.82%, 9.78 mg/g) was recorded at the optimum conditions (initial MB concentration = 50 mg/L, dose = 0.5 g/L, pH 11, contact time = 150, temperature 45 °C). Hence, the hydrochar produced in this work has shown promise for scalability.
No takes yet. Share an insight, caveat, or question.
Mtweve et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: