Answers are grounded in this paper and cite their sources.
This work presents the aerodynamic and structural analysis of the wing section of a two-seat light aircraft with a maximum take-off mass of 600 kg. The wing is rectangular in plan, with a span of 9.0 m, a chord of 1.4 m and an area of 12.6 square metres, giving a wing loading of 467 N per square metre. The study compares two common light-aircraft airfoils, NACA 2412 and NACA 4415, and then examines a wing box made of a front spar, a rear spar, ribs and skin under the lift load of a symmetric manoeuvre. The aim is to select an airfoil and a structural material that give low cruise drag, a safe stall margin, adequate stiffness and the least possible mass. Two-dimensional airfoil analysis was carried out in ANSYS Fluent on a C-type structured mesh of about 210,000 cells with the k-omega SST turbulence model at a Reynolds number of 4.8 million, which corresponds to a cruise speed of 50 m/s. For NACA 2412 the computed maximum lift coefficient is 1.58 at a stall angle of 16 degrees, the minimum drag coefficient is 0.0068 and the best lift-to-drag ratio is 104 at 6 degrees. NACA 4415 reaches a higher maximum lift coefficient of 1.71 at 14 degrees, but at the cruise lift coefficient of 0.31 its drag coefficient is 0.0081 against 0.0069 for NACA 2412. NACA 2412 was therefore selected, and the semi-span wing box was modelled in CATIA with a main spar at 25 percent chord, a rear spar at 65 percent chord, fifteen ribs and 1.0 mm skin. A static structural analysis in ANSYS Mechanical was performed at the limit load factor of 3.8, which gives a half-wing lift of 11,183 N distributed spanwise by the Schrenk method and a root bending moment of about 21.4 kN m. Three materials were compared: aluminium alloy 2024-T3, aluminium alloy 6061-T6 and a carbon fibre reinforced polymer with unidirectional spar caps and quasi-isotropic skins. The aluminium 2024-T3 wing box shows a tip deflection of 112 mm, a peak von Mises stress of 214 MPa at the main spar root and a factor of safety of 1.61 on yield, with a half-wing box mass of 18.4 kg. The 6061-T6 box of the same geometry deflects 119 mm but its factor of safety falls to 1.29, which is below the required 1.5. The CFRP box deflects 96 mm, has a factor of safety of 2.24 against the allowable laminate stress and weighs 11.6 kg, which is 37 percent lighter than the 2024-T3 box.
No takes yet. Share an insight, caveat, or question.
K. Srinivasa Rao, K.Shiva Krishna, CH.Rohith Raghava, G.Sanjay, S.Shiva krishna (2026) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: