Answers are grounded in this paper and cite their sources.
Purpose: This study examined how a laboratory-scale, 20-L Up-flow Anaerobic Hybrid Reactor (UAHR) performs and how it behaves kinetically when it treats raw distillery spent wash. The spent wash was fed without dilution at a COD of 115,000 mg/L (115 g/L). Other characteristics were BOD₅ of 55,000–65,000 mg/L, total dissolved solids of 80,000–130,000 mg/L and sulphate of 6,000–7,000 mg/L. Design/Methodology/Approach: The reactor had a lower suspended sludge blanket (60% of the volume) and an upper packed bed (30%) filled with high-porosity HDPE K1 Micro bio-carriers; the remaining 10% was used for gas–liquid–solid separation. It was run continuously at 37 ± 1°C in a thermostatically controlled chamber, with the inlet pH set to 7.0 ± 0.2. The hydraulic retention time (HRT) was reduced in eight steps from 20 to 4 d at a constant inlet COD of 115 g/L, which raised the organic loading rate (OLR) from 5.75 to 28.75 g COD/L·d. The COD data were fitted to the linearised Modified Stover–Kincannon and Grau second-order equations. Research Limitation: At the 4-d HRT, removal fell to 45.0% as VFA built up and dissolved salts added osmotic stress. The biomass held on the carrier was not measured, so its contribution to stability is inferred, not shown. The results set working limits for this reactor and feed and give preliminary design values only. Findings: At steady state, the best COD removal was 91.0% (effluent COD 10.35 g/L) at the 20-d HRT and an OLR of 5.75 g COD/L·d. Removal stayed at 89.0, 86.0 and 82.0% at HRTs of 16, 14 and 12 d, then dropped from 75.0% to 60.0% between 10 and 6 d. At the 4-d HRT (OLR 28.75 g COD/L·d), removal was 45.0%, volatile fatty acids (VFA) had risen to 4,350 mg/L (as acetic acid), and the effluent pH had fallen to 6.92. Osmotic stress from dissolved salts may have added to this, but the reactor did not fail. The Modified Stover–Kincannon model gave a maximum utilisation rate (Umax) of 22.37 g COD/L·d and a saturation constant (KB) of 18.24 g COD/L·d (linearised R² = 0.9942). The Grau second-order model gave a = 5.14 d and b = 0.8155 with the same R²; at a constant inlet COD, the two models are mathematically equivalent. Practical Implication: The UAHR handled undiluted, high-strength spent wash well at HRTs of 20 to 6 d (OLR up to 19.17 g COD/L·d), and removal stayed above 80% at HRTs of 12 d and longer. The fitted constants can serve as a starting point for sizing high-rate systems for distillery effluent, provided they are confirmed at pilot scale. Social Implication: Effective treatment of highly concentrated raw distillery effluent can support improved industrial wastewater management and help reduce the environmental impact associated with the discharge of high-strength organic and inorganic wastewater. Originality/Value: The paper reports how a hybrid reactor copes with strong spent wash across eight HRTs, tracking pH, temperature, and VFA throughout, and re-examines two common kinetic models using the resulting COD data.
No takes yet. Share an insight, caveat, or question.
Bansode et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: