Answers are grounded in this paper and cite their sources.
The terminal placement of surface anchors and redox reporters is a fundamental but often under-optimized design parameter in electrochemical DNA-based sensors. Most architectures use a 5’ thiol anchor and a 3’ methylene blue reporter by convention, although switching these terminal modifications can alter probe orientation, target accessibility, reporter behavior, and signal transduction. Here, we systematically investigated the effect of switching thiol anchors and methylene blue reporters across three electrochemical DNA-based sensor architectures: an electrochemical DNA sensor for complementary DNA detection, an electrochemical aptamer-based sensor for Plasmodium falciparum lactate dehydrogenase detection, and an E-DNA scaffold sensor for antibody detection. Terminal switching produced architecture-dependent effects. In asymmetric electrochemical DNA sensors, switching increased signal gain and produced a lower apparent dissociation constant under matched-frequency interrogation (24.1 vs 7.8 nM for ORI and SWI, respectively). In the aptamer-based sensor, switching generated a low-frequency signal-ON response and improved signal gain at selected interrogation frequencies. By contrast, in the E-DNA scaffold sensor, the original orientation outperformed the switched architecture, producing a higher signal change, improved signal-to-background ratio, and faster apparent response kinetics. These results demonstrate that terminal modification placement is not a neutral synthetic choice but a determinant of signal transduction and analytical performance. More broadly, this work establishes terminal switching as a simple design variable for tuning electrochemical DNA, aptamer-based, and scaffold-based sensors through deliberate optimization of terminal architecture.
No takes yet. Share an insight, caveat, or question.
Yang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: