Answers are grounded in this paper and cite their sources.
The high‐temperature oxidation behavior of Cu‐containing HTRCr heat‐resistant cast iron in air at 500–900 °C was investigated. The oxide species on the surface of the oxidized material were calibrated using the X‐ray diffractometer (XRD). Scanning electron microscopy and energy‐dispersive spectroscopy were employed to analyze the morphology and composition of the oxide films on the surfaces and cross‐sections. The results indicate that the oxidation resistance of HTRCr‐0.1Cu and HTRCr‐0.2Cu cast iron was similar at 500, 600, and 700 °C. At 800 and 900 °C, HTRCr‐0.2Cu exhibited superior oxidation resistance compared to HTRCr‐0.1Cu. The increase of Cu content reduced the oxidation weight gain rates of HTRCr cast iron by 2.26 mg·cm −2 ·h −1 (800 °C) and 2.28 mg·cm −2 ·h −1 (900 °C), respectively. In the early stages of oxidation, Cr was preferentially oxidized and combined with iron oxides to form (Fe 0.6 Cr 0.4 ) 2 O 3 . With the extension of oxidation time, the oxide film was gradually layered. The outer layer was composed of Cu x Mn 1− x Fe 2 O 4 , Fe 2 O 3 , and Fe 3 O 4 , and the inner layer was composed of (Fe 0.6 Cr 0.4 ) 2 O 3 , Cu x Mn 1− x Fe 2 O 4 , Fe 2 O 3 , and Fe 3 O 4 . A higher Cu content promoted the formation of spinel‐like Cu x Mn 1− x Fe 2 O 4 , significantly enhancing the compactness of the inner oxide layer and improving the oxidation resistance of HTRCr cast iron.
No takes yet. Share an insight, caveat, or question.
Qiu et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: