Answers are grounded in this paper and cite their sources.
Foam-assisted gas injection enhances sweep efficiency during gas flooding but faces challenges due to foam degradation in high-salinity reservoirs and crude oil presence. This study evaluates the performance of three alkyl polyglucosides (APGs) with average chain lengths of 8.5, 10, and 12, along with the synthetic nonionic surfactant Triton X-100, for flooding of high-salinity foam. Chemical screening assessed aqueous stability, surface and interfacial tension (IFT), and foam stability in the presence and absence of medium crude oil, considering foam generation methods. The results show that APGs outperform Triton X-100 in foam stability under high-salinity, oil-rich conditions. Coco glucoside and APG0810 reduced oil–water IFT by 88.6% ± 0.6 and 88.3% ± 1.2, respectively, while Triton X-100 achieved a 93.5% ± 0.5 reduction, indicating strong surface activity for all surfactants. Coco glucoside demonstrated superior foam stability, with only a 4% reduction in CO2 foams and a 6% stability increase in N2 foams upon oil introduction. Triton X-100 exhibited stability losses of 16% and 17% in CO2 and N2 foams, respectively. Air foams produced by blending were highly susceptible to oil, with complete destruction observed for all surfactants except decyl glucoside, which retained some stability despite a 94% reduction. Gas-sparged foams were less affected, with coco glucoside showing the smallest stability loss among APGs at 19%. These findings identify coco glucoside as the most promising APG for CO2 foam flooding in high-salinity, low-temperature, oil-rich reservoirs.
No takes yet. Share an insight, caveat, or question.
Ikyerga et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: