Answers are grounded in this paper and cite their sources.
Diamond-like carbon (DLC) coatings have attracted significant interest for applications requiring low friction and high surface durability. Consequently, various DLC formulations have been developed to meet different tribological demands. In this study, the frictional behavior of AISI 4140 carbon steel, which is a widely used high strength structural material, was investigated following surface modification with two distinct DLC coating configurations. Specifically, Cr‒doped DLC with a graded CrCN interlayer (Cr‒DLC/CrCN) and AlTi-doped DLC with a graded AlTiCN interlayer (Al:Ti‒DLC/AlTiCN) were compared. Wear tests were performed using the ball-on-flat method. The results show that the Cr‒DLC/ CrCN coating exhibited a lower coefficient of friction (0.26) than the Al:Ti‒DLC/AlTiCN coating (0.30). Laser scanning confocal microscopy also revealed a smaller wear track on the Cr‒DLC/CrCN surface, with a reduced depth (2.52 µm) and width (496.68 µm). Raman spectroscopy indicated a higher sp2 bonding fraction in the Cr‒DLC/CrCN coating, as reflected by its increased ID/IG ratio, which contributed to its lower friction behavior. Overall, the Cr‒DLC/CrCN coating demonstrated superior tribological performance and wear resistance, making it a more promising surface modification for enhancing the durability of AISI 4140 carbon steel in severe sliding wear environments, typical in oil and gas industries.
No takes yet. Share an insight, caveat, or question.
Pintitraratibodee et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: