Answers are grounded in this paper and cite their sources.
This study compares the tensile and flexural properties of four fused deposition modelling (FDM)-printed polymer systems—polylactic acid (PLA), glycol-modified polyethylene terephthalate (PETG), high-impact polystyrene (HIPS), and carbon-nanofiber-reinforced nylon (N+CF)—as preliminary candidates for lower-limb prosthetic component development. The recorded ultimate tensile strengths were 38.0, 34.5, 7.5, and 16.7 MPa, respectively, while the corresponding flexural strengths were 70.0, 60.0, 10.5, and 31.5 MPa. PLA exhibited the greatest mechanical resistance under both loading modes, followed by PETG, N+CF, and HIPS. Compared with PETG, PLA demonstrated 10.1% higher tensile strength and 16.7% higher flexural strength. Flexural-to-tensile strength ratios ranged from 1.40 (HIPS) to 1.89 (N+CF). These trends are evaluated in terms of polymer deformation behavior, inter-road bonding integrity, manufacturing defects, and processing parameters. While the experimental results provide a quantitative baseline for preliminary material screening, establishing clinical structural adequacy requires subsequent fatigue testing, statistical replication, and full-scale component validation.
No takes yet. Share an insight, caveat, or question.
Kannan et al. (2026) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: