Answers are grounded in this paper and cite their sources.
Street lighting is one of the largest single items in the electricity bill of a municipality, and in many Indian towns a large part of that energy is wasted. Lamps are switched on too early in the evening, left burning after sunrise, and kept at full brightness through the late night hours when roads are almost empty. Manual switching by line staff and fixed timers cannot follow the change in sunset and sunrise times across the year, and faults in individual lamps are usually discovered only after residents complain. This paper presents an IoT based automatic street light control system that uses a Light Dependent Resistor (LDR) to sense ambient light and switch and dim the lamps so that energy is used only when and where it is needed. The proposed system uses an ESP32 microcontroller at each pole cluster. An LDR connected in a voltage divider gives an analog voltage that falls as daylight increases, and the controller reads this voltage through its analog to digital converter to decide when dusk and dawn have arrived. Passive infrared (PIR) sensors placed along the road detect the movement of vehicles and pedestrians. The LED luminaires are driven through a MOSFET based PWM dimming stage, so the lamps run at a low standby level of about 30 percent during quiet hours and rise to full brightness within a second when movement is detected. Electrical quantities are measured continuously at the lamp side. An ACS712 current sensor and a resistive voltage divider allow the controller to estimate the power drawn by each lamp group, from which the energy consumed in kWh is calculated and stored. A sudden drop in current while the lamp is commanded on is treated as a lamp failure, and a current above the rated value is treated as an overload that trips a relay to protect the driver and wiring. A small battery backed by a charge controller keeps the controller and communication module running during supply interruptions so that events are not lost. Readings and events are published over Wi-Fi to a cloud platform using the MQTT protocol. A web dashboard shows the on and off status of every lamp group, daily and monthly energy use, the energy saved against a conventional full brightness schedule, and a list of faults with their location.
No takes yet. Share an insight, caveat, or question.
Rao et al. (2026) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: