Answers are grounded in this paper and cite their sources.
Fully stretchable electronics require conductors, dielectrics, and thermally conductive layers that deform together without mechanical mismatch. Liquid metal particles (LMPs) are attractive building blocks for such systems, but their gallium oxide shells leave LMP films electrically insulating, so controlled sintering is required. This work reports a peel‐transfer strategy in which LMPs sinter during a single peeling step, and establishes how processing parameters control the outcome. Particle diameter, peeling angle, peeling speed, polymer type, and substrate surface state govern the wetting‐driven capillary infiltration of the polymer and the position and stability of the fracture path, which together decide whether particles remain isolated or rupture and coalesce. These relations provide design rules for producing insulating, weakly conductive, and highly conductive patterns from one LMP ink. Applying the rules spatially, through particle‐size patterning, dynamic control of the peeling angle, and substrate pre‐patterning, makes the sintering programmable, defining conductive and insulating regions within a single LMP film at a resolution of 27 µm. Interdigitated electrodes with high‐permittivity dielectric regions and light‐emitting diode patches with integrated heat‐spreading layers, each fabricated in one peeling step, demonstrate the applicability of this strategy. These design principles offer a route to monolithic, mechanically matched stretchable liquid metal‐based electronics.
No takes yet. Share an insight, caveat, or question.
Li et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: