Answers are grounded in this paper and cite their sources.
This article presents a unified analytical and finite-difference electrothermal framework, implemented in Python, for evaluating coated and uncoated copper and aluminum conductors subjected to sinusoidal and Fourier-derived non-sinusoidal currents. The modified current is obtained by full-wave rectification of a sinusoidal function and represented by a truncated Fourier series. The formulation couples temperature-dependent electrical resistivity and conductor geometry with frequency-dependent AC resistance and a skin-effect correction applied to each retained harmonic component. The DC and harmonic Joule losses are calculated separately and used as thermal sources in lumped analytical and one-dimensional distributed models. The convergence analysis showed that N = 11 yields a normalized root-mean-square error (NRMSE) of approximately 0.36%, with negligible thermal variation relative to higher truncation orders. For a 16 mm 2 copper conductor carrying a 130 A peak current at 60 Hz over 2 h, the PVC-like coating reduced the final temperature from approximately 92.21 °C to 60.27 °C, corresponding to a 47.53% reduction in temperature rise above ambient. This reduction follows from the critical radius of insulation and persists for convection coefficients below approximately 60 W m − 2 K − 1 . The sinusoidal and modified currents produced final-temperature differences below 0.003 °C, although their time-domain electric-field responses were markedly different. For a six-pulse rectifier current with the same RMS value and a total harmonic distortion of 29%, the harmonic-resolved losses of the same conductor increased by only 0.07%. Aluminum produced higher temperatures and electric-field amplitudes than copper. The constant-coefficient lumped solution underestimated the mid-length temperature of the distributed model, which includes resistivity feedback, by up to approximately 14 ° C for the uncoated copper conductor, whereas a closed-form fin solution with linear resistivity feedback reproduced the finite-difference integral-mean and mid-length temperatures within 0.05 ° C for the copper cases. Overall, conductor material and coating configuration primarily governed the thermal response, whereas harmonic content mainly affected the time-domain field and frequency-dependent losses.
No takes yet. Share an insight, caveat, or question.
Silva et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: