Answers are grounded in this paper and cite their sources.
As every point at the crack tip should reach the same extent before failure under no change in constraint, it is logical to believe that some kind of self-similarity in crack evolution must be achieved. The active plastic field at a growing crack tip has a fixed geometric character, which has not been tested directly. We tracked a crack tip continuously by in situ scanning electron microscopy during ductile tearing of 316L stainless steel single-edge-notched tension specimens, and measured the box-counting dimension of the deformation structure inside a constant-area window that followed the tip. Over 227 μm of crack growth, during which J rose from 91 to 280 kJ m−2, the box-counting dimension was invariant, Dbox = 1.145 ± 0.021, with a regression slope of −0.006 ± 0.007 over 220 μm (p = 0.33). A second, independent test on a 316L weldment, with a different initial crack length (a0/W = 0.616 against 0.490) and with the crack running out of weld metal towards base metal, returned Dbox = 1.189 ± 0.129 against 1.168 ± 0.151 for the first specimen when both are measured in the same 75 μm window (p = 0.12). Beyond maximum load, the crack in that specimen turns out of its original plane, and the growth becomes mixed mode, which is where a single-parameter description stops applying; the measurement is reported to that point. In the same windows, the intensity of deformation grew strongly: twin-like lineal density rose more than two-fold and slip-trace density rose by about 70% in both specimens. Crack advance, therefore, amplifies near-tip plasticity without altering its geometry.
No takes yet. Share an insight, caveat, or question.
Tiwari et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: