Answers are grounded in this paper and cite their sources.
Conventional ton-kilometer-per-hour (TKPH) procedures for ultra-large off-the-road (OTR) tires compute the mean tire load from a fixed static axle split and correct only for cycle length and ambient temperature, so the axle-load transfer caused by longitudinal haul-road grade is ignored. This study derives an axle-specific TKPH model from the rigid-body equilibrium of a haul truck on a grade, in which the loaded truck travels uphill and the empty truck downhill, and the mean tire load of each axle is computed from the grade-dependent normal reactions. Linearization of the model yields closed-form grade coefficients that depend only on vehicle mass, wheelbase and centre-of-gravity coordinates. The parameters were measured for four truck classes at the Muruntau open-pit mine (Uzbekistan). For a Komatsu 830E operating at 45 °C, a 10% grade changes the full-cycle TKPH by −11.3% on the front axle and +6.1% on the rear axle (−1.08% and +0.67% per grade point), and the TKPH of the loaded uphill leg by −28.2% and +13.2%. The linear correction factors reproduce the full model within 0.5% for grades up to 10%, and the predicted static axle split agrees with manufacturer data within 0.5 percentage points. After the method was introduced into the monitoring of 40.00R57 tires, the share of premature removals decreased from 62.1% to 45.6% (p < 0.001) and the mean removal mileage increased by 4.56%, although concurrent changes in the tire supplier mix prevent attributing these changes solely to the method. The model provides a transparent basis for axle-specific tire selection and route-sensitive thermal-risk assessment.
No takes yet. Share an insight, caveat, or question.
Ergashev et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: