Answers are grounded in this paper and cite their sources.
Porous ceramics are attractive for high‐temperature thermal insulation, heterogeneous catalysis, and gas filtration, but their practical service is largely constrained by the inherent strength–porosity trade‐off, especially when total open porosity exceeds 70 vol.%. This work introduces a scalable secondary slurry‐infiltration route applied to freeze‐foamed yttria‐stabilized zirconia (YSZ) preforms after low‐temperature pre‐sintering, designed to promote inter‐particle neck development and refine pore‐wall defect distribution without substantial permeability loss. Three critical processing variables were systematically evaluated for their effects on final porosity and mechanical performance. Under comparable total porosity above 80 vol.%, all infiltrated samples exhibit compressive strength 1.2–1.9 times higher than their non‐infiltrated counterparts. The strategy demonstrates clear potential for manufacturing high‐porosity ceramics with simultaneously retained high permeability and substantially improved structural integrity.
No takes yet. Share an insight, caveat, or question.
Lang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: