Answers are grounded in this paper and cite their sources.
Poly(butylene adipate-co-terephthalate) (PBAT) samples were irradiated at the absorbed doses up to 50 kGy by gamma rays with a dose rate of 0.92 kGy h−1 and an electron beam (EB) accelerator with a dose rate of 3.5 kGy s−1 to modify properties for further applications. The results revealed that radiation modalities significantly affected PBAT. The peroxide value (PV) of the irradiated PBAT increased sharply with the absorbed dose of gamma irradiation, but this value only increased slightly by EB irradiation. The viscosity average molecular weight of PBAT significantly decreased by gamma ray irradiation, indicating that the chain scission predominantly occurred. In contrast, EB irradiation does not seem to have affected the Mv of the irradiated PBAT, suggesting the occurrence of competing radiation-induced reactions, including chain branching and crosslinking, which may limit chain scission. Furthermore, oxidative reactions also contributed to the structural changes in PBAT during irradiation, as indicated in FT-IR spectra. The comparative results suggested that gamma irradiation led to a gradual increase in the melt flow index (MFI) and a decrease in the tensile strength and elongation at break of irradiated PBAT with increasing absorbed doses. In contrast, the MFI of EB-irradiated PBAT leveled off with the absorbed dose. The tensile strength of the EB-irradiated PBAT was slightly reduced with the absorbed dose, but its elongation at break significantly decreased at doses below 20 kGy and then recovered with doses up to 50 kGy. These findings demonstrate that gamma and EB irradiation can be applied as effective tools to modify PBAT.
No takes yet. Share an insight, caveat, or question.
Tran et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: