Answers are grounded in this paper and cite their sources.
The commercialization of all‐solid‐state Li–S batteries (ASSLSBs) remains constrained by the “impossible trinity” between high energy density, long cycle life, and low stack pressure. Here we show that stack pressure is not merely a static mechanical boundary, but a stage‐specific regulator of sulfur conversion and interfacial reconstruction. Using a static pressure‐resistance‐overpotential (P‐R‐η) operational threshold algorithm, low‐stack‐pressure operation is predicted feasible for 50 wt% S cathodes. Further operando electrochemical measurements and multiscale chemical and structural characterizations reveal that 1 MPa discharge promotes Li 2 S 2 ‐rich interfacial intermediates. However, constant low‐pressure cycling induces progressive pore filling that prolongs charge transport pathways, leading to inactive Li X S accumulation and triphase interfacial contact losses. State‐resolved very‐small‐angle neutron scattering (VSANS) further uncovers a ∼5 nm structural feature that persists after low‐stack‐pressure discharge, which specifically diminishes upon high‐pressure charging. Guided by this mechanism, we implement a pressure‐programmed protocol combining 1 MPa discharge with 180 MPa charge. The resulting cell retains 98.8% of capacity after 100 cycles at 30 °C. This work establishes a dynamic pressure modulation strategy towards alleviating the “impossible trinity” by decoupling the asymmetric pressure‐electrochemical behaviors.
No takes yet. Share an insight, caveat, or question.
Zhang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: