Answers are grounded in this paper and cite their sources.
Hot rolling work rolls are subjected to repeated thermal and mechanical loading, while oxidation and wear alter their surface conditions. This study investigates the effects of residual stress, oxide film evolution, and material removal on fatigue damage in hot rolling work rolls. Residual stresses generated during heat treatment are introduced into a thermomechanical rolling model to determine the local near-surface strain response. Oxide film growth and removal are described using a dynamic model, with predicted thicknesses compared against high-temperature sliding wear measurements. Fatigue damage is evaluated using the Manson-Coffin strain-life relationship and Miner’s linear damage rule. Measured roll surface recession and calculated oxide film thickness are used to update the metal-oxide interface position and track fatigue damage redistribution in the remaining material through successive rolling cycles. Initial residual stress increases the peak equivalent strain from 0.0049 to 0.0077 and changes the near-surface fatigue damage distribution. The calculated oxide thickness follows the overall experimental trend, although deviations occur at intermediate wear times. Material removal reduces retained fatigue damage, while changes in oxide film thickness affect its distribution through movement of the metal-oxide interface. Sensitivity analysis shows that wear depth has the greatest influence on retained fatigue damage, with coefficients ranging from − 0.82 to -0.85, followed by residual stress and oxidation. These findings support fatigue damage assessment of worn work rolls and may assist in determining suitable regrinding depths.
No takes yet. Share an insight, caveat, or question.
Tao et al. (2026) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: