Answers are grounded in this paper and cite their sources.
This study evaluates the technical feasibility of mechanically recycling highly concentrated epoxy/carbon nanotube (CNT) thermoset composites by grinding them and reincorporating the recyclate into three thermoplastic matrices that differ in polarity and crystallinity: polystyrene (PS), polypropylene (PP), and polycarbonate (PC). Blends containing 0 (neat control), 5, 10, and 20 wt% recyclate were prepared by dry blending and injection molding, without compatibilizers. The recyclate affected each matrix differently. In flexure, 20 wt% recyclate increased the modulus, ultimate strength, and energy at break of PC by more than 10%; for PP, the modulus and energy at break increased with loading while the ultimate strength changed little; and for PS, the modulus was unchanged while the ultimate strength and energy at break decreased by about 20% and 50%, respectively. In tension, the ultimate strength and energy at break decreased for all three matrices, most sharply for PC and PP, while the Young’s modulus was maintained or increased slightly. In air, degradation began at higher temperatures for PS and PP but at lower temperatures for PC. These results show that the route is technically feasible for parts loaded mainly in bending rather than tension and that interfacial compatibility must be improved before broader use.
No takes yet. Share an insight, caveat, or question.
Acha et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: