Answers are grounded in this paper and cite their sources.
The effect of minor gallium additions (0, 0.5, and 1 wt. %) on the liquid-phase sintering process, microstructure, and magnetic properties has been investigated for isotropic samples sintered in situ in a thermal analyzer and anisotropic permanent magnets based on the (Nd,Pr)–(Fe,Co,Ga,Cu,Al)–B system. Using in situ differential scanning calorimetry and thermogravimetric analysis, it is established that the introduction of gallium significantly modifies the liquid-phase sintering process: the temperature range of melting of low-melting phases narrows, and the thermal effect is reduced. A substantial influence of gallium on the optimal regimes of the subsequent two-step heat treatment has been discovered: with an increase in its content to 1 wt. %, the temperature of the high-temperature annealing T1 decreases by 90 °C (from 910 to 820 °C) and that of the low-temperature annealing T2 by 60 °C (from 540 to 480 °C). For anisotropic magnets, doping with 0.5 wt. % Ga leads to the optimization of the grain-boundary microstructure and a significant increase in the coercivity (HcJ up to 17.1 kOe) and maximum energy product [(BH)max up to 44.6 MG Oe].
No takes yet. Share an insight, caveat, or question.
Сташкова et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: