Answers are grounded in this paper and cite their sources.
Heavily boron-doped p -type Si layers were fabricated by thermal diffusion using B 2 O 3 . The effects of precursor concentration and annealing temperature on their electrical, morphological, and structural properties were investigated. The hole carrier concentration estimated from the sheet resistance increased systematically with increasing B 2 O 3 concentration and annealing temperature, reaching 5.85 × 10 19 cm −3 at 850 °C with 1.4% B 2 O 3 . The surface roughness of this sample was 0.143 nm and was further reduced to atomically smooth 0.076 nm by chemical mechanical polishing. X-ray diffraction and reciprocal-space mapping confirmed the preservation of high crystalline quality, while asymmetric rocking curves suggested depth-dependent strain associated with boron incorporation. Micro-Raman mapping revealed spatial variations in the local lattice state, which became more uniform after polishing. These results demonstrate a process for producing heavily doped p -type Si with high crystalline quality and an ultra-flat surface for low-resistance interfaces in Si-based spintronic devices.
No takes yet. Share an insight, caveat, or question.
Ishikawa et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: