Answers are grounded in this paper and cite their sources.
Porous media modeling is often retained in the nuclear industry for the thermal-hydraulics component scale simulation of the core and of steam generators. In this approach, the fuel/tube bundle solid boundaries are not explicitly simulated, and their presence is modeled by a volume porosity and a pressure drop source term in the momentum equations, the goal of which is to describe the forces induced by the structures on the flow. This paper attempts to assess the consistency of the pressure drop formulation in 3D cylinder bundle configurations. The first part of the paper describes the possible tensor formulations and proposes a simple test case to show potential weaknesses in reproducing experimental data. For the tensor formulations tested, it was not possible to obtain the pressure drop corresponding to the correlation value, for angles of the flow different than 0 and 90 deg with respect to the tube direction. In the second part of the paper, a 3D external single-phase flow across an oblique tube bundle is considered: the tube bundle is made of 20 × 20 triangular-pitch straight tubes, with a 45-deg angle between the tubes and the free stream. This configuration was simulated through both a porous media and a computational fluid dynamics (CFD) approach (RANS). CFD results are averaged along control volumes representative of the porous media simulation scale. The velocity profiles calculated by the two approaches are compared along different profiles inside the tube bundle: regions with different flow deviation predicted by the two approaches are identified.
No takes yet. Share an insight, caveat, or question.
Daniele Vivaldi (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: