Answers are grounded in this paper and cite their sources.
Focused ion beam systems, typically of gallium ions, have become widely used for the study and fabrication of micro- and nanostructures. The focused ion beam method, used for prototyping optical devices, makes it possible to create surface relief with low roughness. However, implantation of gallium ions into the processed material causes a significant deterioration in the functional characteristics of optical devices. The paper shows that line-by-line scanning with a focused ion beam allows the formation of axisymmetric structures in silicon dioxide substrates in the form of Fresnel phase plates with a low content of implanted gallium. The templates for fabricating the structures consist of two concentric rings with an inner radius of 3.13 and 5.42 μm and a width of 1.30 and 0.84 μm, respectively. Using optical microscopy and energy-dispersive X-ray microanalysis in transmission electron microscopy, the obtained recesses were compared with the recesses of similar structures produced by standard multi-pass scanning. It was found that with line-by-line movement of the ion beam, the peak concentration of gallium atoms in the near-surface region of the sample is less than 5 at % with multi-pass scanning – approximately 33 at %, the thickness of the gallium-enriched layer decreases by approximately half and is close to 20 nm. It was found that such a decrease in the concentration of gallium atoms leads to an increase in the transparency of quartz glass in the ion beam-treated areas of the substrate for structures manufactured by line scanning.
No takes yet. Share an insight, caveat, or question.
Rumyantsev et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: