Answers are grounded in this paper and cite their sources.
Abstract― A prerequisite for the creation of reproducible photomask technology is the adhesive strength of the functional layers. Therefore, it is important to consider the reasons that determine the adhesion of films and the influence of various factors on the adhesive strength. The work investigated the adhesion of a photoresistive mask and thin-film functional layers of Cr, MoSiN, MoSiN/Cr photomasks and photomask blanks with design standards of 90–65 nm. A method for measuring the adhesive strength of films has been developed. The studies were conducted on prototype photomasks and photomask blanks on which functional layers were formed by magnetron sputtering. It was found that the values of the adhesion strength of the functional layers on photomasks and photomask blanks differ slightly, while the profiles of the adhesion values on their surfaces are similar. The adhesive strength of Cr, MoSiN, and MoSiN/Cr layers formed by magnetron sputtering on quartz substrates from different manufacturers is at least 1800 g/mm2, however, in some cases cohesive failure of quartz is observed at a tear force of about 1400 g/mm2. When examining the mechanisms of adhesion of functional layers, it was found that the adhesive strength is determined mainly by van der Waals forces. In the process of measuring the adhesive strength of functional layers, cohesive destruction of the quartz substrate occurs in 60% of cases. Cohesive destruction of covalent Si–O bonds occurs at a depth of more than 150 nm in the quartz substrate. The results of the studies showed high values of adhesive strength of the formed functional layers of photomasks and photomask blanks.
No takes yet. Share an insight, caveat, or question.
A. V. Anikin (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: