Answers are grounded in this paper and cite their sources.
A new 10 MW research reactor is planned at the Monju site in Japan as a successor facility for neutron- and positron-beam applications. To support the design of a positron source for this planned facility, Monte Carlo radiation-transport simulations were used to assess how candidate spatial layouts of the positron source assembly and geometries of the photon–positron converter affect positron yields in a simplified model of the new reactor’s heavy-water tank. A simplified heavy-water tank model with a segmented planar neutron source was developed and calibrated by comparing the calculated thermal-neutron-flux profile with results from a previously reported full-core simulation. This model was then used to calculate the emitted positron yields for various candidate layouts. The positron source assembly comprised a cadmium neutron–photon converter and a tungsten (W) photon–positron converter. Variations in the horizontal position, vertical position, and insertion angle of the positron source assembly were evaluated. The highest yield was obtained when the assembly was positioned closest to the surface of the fuel assembly. Although layout adjustments to avoid interference with other beamlines reduced the yield, even cases with the lowest yields retained roughly half of the maximum value. The candidate layouts therefore involve a trade-off between maximizing the emitted positron yield and avoiding interference with other beamlines. In contrast, the internal geometry of the positron source assembly had a much larger effect. Replacing the W disk with a honeycomb structure of 91 thin-walled W tubes increased the emitted positron yield by a factor of 14, suggesting that optimization of the assembly’s internal structure could be a promising strategy for increasing yield.
No takes yet. Share an insight, caveat, or question.
Atsushi Yabuuchi (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: