Answers are grounded in this paper and cite their sources.
This study investigates the effects of cooling severity on the microstructure, mechanical properties, and solid particle erosion behavior of ASTM A537 pressure-vessel steel. Specimens were austenitized at 900 °C and subjected to air cooling, salt-bath cooling at 300 °C, oil quenching, and water quenching, followed by tempering of the water-quenched condition. The microstructure evolved from ferrite–pearlite (FP) in the air-cooled condition to predominantly bainitic ferrite (BF) with substantial retained austenite (RA) in the salt-bath cooled condition, finer BF with lower RA and a possible minor martensitic contribution in the oil-cooled condition, and predominantly martensitic (M) structure after water quenching. Increasing cooling severity (in the order A537A < A537S < A537O < A537W) increased yield strength, compressive strength and hardness, whereas UTS gains were limited to the water-quenched condition and ductility generally decreased. The water-quenched condition exhibited the highest yield strength (530 MPa), ultimate tensile strength (630 MPa), compressive yield strength (610 MPa), and hardness (431 HV), while the air-cooled condition showed the highest elongation (38%). Notably, the water-quenched condition retained a relatively high elongation of approximately 28% despite its predominantly martensitic structure. Fractographic analysis revealed predominantly ductile dimple rupture in the salt-bath and oil-cooled conditions, whereas the water-quenched condition exhibited a mixed, lath-controlled tearing morphology with localized microvoid coalescence. Solid particle erosion tests at a 45° impact angle, performed on the FP (air-cooled) and martensitic (water-quenched) conditions, showed a strong relationship between hardness and erosion resistance, with the water-quenched condition exhibiting approximately half the mass loss of the FP condition after 15 min. These findings establish a structure–property–erosion relationship for A537 steel and provide a basis for selecting heat-treatment routes, pending further evaluation of toughness and service performance for pressure-vessel applications.
No takes yet. Share an insight, caveat, or question.
Roghanian et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: