Answers are grounded in this paper and cite their sources.
Human-motion energy harvesting can extend the operating time of wearable devices. However, conventional electromagnetic energy harvesters are constrained by magnet trajectories and have difficulty accommodating low-frequency, irregular, and multidirectional excitation. This paper proposes and experimentally investigates a multi-degree-of-freedom spherical electromagnetic energy harvester (SEEH) for low-frequency energy harvesting. The SEEH comprises symmetric upper and lower winding regions and a spherical cavity containing a freely moving spherical magnet. The RMS output voltage increases with excitation frequency up to 4.5 Hz and then decreases at 5 and 6 Hz. The maximum RMS voltages in the vertical and horizontal orientations are 1.898 and 1.939 V, respectively. In the vertical orientation, the lower winding region produces a higher RMS voltage than the upper region, whereas in the horizontal orientation, one winding region produces about half the voltage of the full-winding configuration at most frequencies. At 4.5 Hz in the horizontal orientation, the highest mean output power among the tested load resistances is approximately 2.11 mW at 150 Ω. A preliminary hand-held reciprocating-motion test shows that the rectified output can keep three LEDs illuminated. The comparable outputs in the two tested orientations indicate the potential of the SEEH for low-frequency energy harvesting from different directions, although standardized on-body tests are still required under actual human-motion conditions.
No takes yet. Share an insight, caveat, or question.
Liu et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: