Answers are grounded in this paper and cite their sources.
This study systematically investigates the flexural behavior of three‐dimensional angle‐interlock woven drilled‐hole composites (3DAWDHC) under low‐temperature conditions. Three 3DAWDHC architectures, namely through‐angle interlocking (TI), shallow‐cross bending (SB), and shallow‐cross straight (SS), were fabricated and subjected to three‐point bending tests over a temperature range of −60°C to 20°C and drilled hole diameters of 0–6 mm. The effects of temperature and hole diameter on peak load, flexural strength, and flexural modulus were quantitatively evaluated. The results demonstrate that both temperature and hole diameter significantly regulate the flexural properties of 3DAWDHC in opposite manners. Taking the TI structure as a representative, flexural strength and flexural modulus increase by 14.6% and 44.0%, respectively, when temperature decreases from 20°C to −60°C, relative to the room‐temperature non‐drilled baseline. By contrast, when the drilled hole diameter increases from 0 to 6 mm at 20°C, flexural strength and flexural modulus decrease by 22.8% and 28.9%, respectively. Regarding failure characteristics, lower temperatures aggravate matrix embrittlement and induce more severe brittle fracture, while larger drilled holes reduce the macroscopic failure area but deepen crack propagation along the thickness direction. These findings provide fundamental data and design guidance for 3D woven joint structures serving in cryogenic aerospace environments.
No takes yet. Share an insight, caveat, or question.
Ren et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: